Product QuestionsAnswered by Jim, the Water Pump Expert
How long can 1 full gas tank last for the BE-HP2065HR?
Man H.
from California
July 02, 2019
Answer
That is a very difficult question to answer, as it really has to do with how hard or easy you are working the pump. Just like driving a car, you can get "good or bad gas mileage." The higher and further you are pumping, the worse "mileage" you will get. On average, however, you should see a good 60-90 minutes of runtime.
Was this answer helpful?
Yes
2
No
0
Hi Jim Is it okay to have the input 2 inch in and reduce the output to a 1 1/2? that would probably increase the PSI a little bit more too, right? or do I have to match both input and output with the same size hose? Thank you.
Marc D
from Minnesota
January 22, 2014
Answer
It is always recommended that you use the same diameter hose/piping as the suction and discharge ports on the pump. While it is sometimes necessary to reduce that diameter, it is NOT recommended that you do so by more than one size. In this case, 1-1/2" hose or piping would be the maximum reduction, While you may see an increased pressure due to the reduced piping, the pump will also see an increased backpressure on the pump. The more you reduce the hose/piping diameter, the more you increase this backpressure AND increase premature pump failure that would NOT be covered under warranty.
Was this answer helpful?
Yes
18
No
2
How-To Articles
How to Pick the Perfect Dewatering Pump
Basements, yards, and construction sites can all flood, but with the help of a ...