Expert Recommended AccessoriesSelected by Jim, our Expert
Required Accessories9
These accessories are required to properly setup/install this product.
Optional Accessories10
Features
Inlet Size
1-1/4 Inch
Style
Shallow Well
GPM
12.6 Gallons
1/2 HP Shallow Well Jet Pump
Ideal for use in pumping at depths of 25' or less
Heavy-Duty Cast Iron Construction
Built for years of reliable service
Includes Factory Pre-Wired 30/50 Pressure Switch
Produces up to 50 PSI with automatic shut-off
115/230 Volt Heavy-Duty Century Motor
Voltage selector for simple connection to existing power source
Glass-Filled Thermoplastic Impeller and Diffuser
For high performance and efficient water flow
Additional Specs
1-1/4" FNPT - Intake
1" FNPT - Discharge
3-Year Limited Warranty
Specifications
602206
General Information
Product Category
Water Pump
Motor
Voltage
120/240 Volt
Running Amps
5.9
Pump
Gallons Per Minute
12.6 Gallons
Inlet Diameter
1-1/4 Inch
Outlet Diameter
1 Inch
Self Priming
No
Housing Material
Cast Iron
Impeller Material
Plastic
Suction Head
25 Feet
Maximum PSI
65
Total Head Lift
150 Feet
Submersible
No
Engine
Oil-Cooled
No
Horsepower
0.5 hp
Overview
Product Category
Water Pump
Weight
36 Pounds
Made in USA
No
Consumer Warranty
3 Years
Product Length
20.5 Inches
Product Width
10.5 Inches
Product Height
10.25 Inches
UPC
010121147027
Additional Model Numbers
RJS-50-PREM, 602206
Reviews
(10)
Red Lion 602206 Reviews & Ratings
Customer Photos and Videos
Product Q&A
(3)
Product QuestionsAnswered by Jim, the Water Pump Expert
What is the best way to prime this pump before using? Is there a built in check valve on the inlet side?
Chris M.
from Michigan
June 08, 2017
Answer
Read our How-To guide on Priming a Well Pump. Otherwise, all installation instructions including priming are available in the Product Manual. You would need to install a foot or check valve on the suction side in order to keep the pump primed.
Was this answer helpful?
Yes
5
No
1
What size tank do I need with this pump?
Byron T.
from Georgia
May 11, 2017
Answer
Tanks for shallow or deep well applications are typically sized based on a minimum 3 times your GPM requirements. So for example, if you NEED 12GPM, you should have a minimum 36 gallon pressure tank.
Was this answer helpful?
Yes
10
No
1
I am interested in this model. My issue is, when i disconnect the old well pump, will there be a pressure/ water issue. What does disconnecting the old pump involve?
Matt K
from Pennsylvania
November 12, 2015
Answer
As all well pumps and wells can vary, it's best to consult with a local certified installer. You might also refer to this pump's INSTALLATION MANUAL for further assistance.
Was this answer helpful?
Yes
0
No
0
How-To Articles
How to Pick the Perfect Well Pump
The days of using a bucket and rope to retrieve water from a well are long gone...