Red Lion 12.8 GPM 3/4 HP Stainless Steel Shallow Well Jet Pump

I ordered two pumps from Water Pumps Direct and both units was very good. No complaints.

This pump is a good value and does what it claim, except the psi output. I am getting 38 psi at 230v with 0 suction pressure. So it's getting about optimum performance. Tank sits above pump and gravity feeds in 1-1/4 pipe and house sit about 10' below the pump. So the only thing it's getting dinged on is psi claims. Otherwise a good deal for a stainless steel booster pump.

Did more than I expected. Pump water about 150 ft level then 50 ft up 45 degrees.

I'm very happy with this pump. It has much better pressure and flow than the one it replaced. Was difficult to get primed, but all has been good since.

If you want a pump that gets the job done without making a lot of noise then this is the pump to get. It is very quiet and also very light weight!

I bought this pump from Water Pumps Direct, installed it, and it is working fine.

Pump is quiet working great after 1st month. Pump is very lite weight compared to the pump I replaced it with. Love the 110 or 220 option. Comes with new pressure switch. Would recommend.

This pump looks really nice and when I received it I took pictures to show my friends that I really did get a stainless pump for less than the lowest price pump in my local department store. When I hooked it up I couldn’t seem to stop drips from both inlet and outlet fittings. I tried new Teflon tape but still drips. I tried pipe dope, still drips, I tried both together, still drips. I should mention that I make connections in 100 psi steam fittings for a living, but I was really puzzled by this. I tried all new brass fittings, but the connections still drip.

Then I went to my local plumbing supply store and the owner asked the manufacturer of the pump. When I said Red Lion the owner told me that pump was made in China and was noted for poor thread quality. I ran a 1” pipe die to clean up the threads and it finally sealed after 6 tries.

Next issue I hooked up electricity, primed the pump, and it pumped water, but would not stop after building pressure. When I manually moved the pressure switch to stop the pump would not start. I figured the pressure switch was bad and proceeded to the plumbing store again. I returned with a new pressure switch and removed the fitting from the original switch only to find out the fitting was clogged with pipe dope from the manufacturer. I was pissed! I really can’t remember purchasing something new with this many issues and so much of my time to correct.

Now that the pump is hooked up and running I don’t believe it pumps volume any faster than the ½ hp pumps I bought at the department store. When the pressure switch was stuck I don’t believe it pumped over 80 psi as the specs claim. It is noisy, but so were the department store pumps. It does the job but it was not worth the hassle.

This pump looks really nice and when I received it I took pictures to show my friends that I really did get a stainless pump for less than the lowest price pump in my local department store. When I hooked it up I couldn’t seem to stop drips from both inlet and outlet fittings. I tried new Teflon tape but still drips. I tried pipe dope, still drips, I tried both together, still drips. I should mention that I make connections in 100 psi steam fittings for a living, but I was really puzzled by... more

We bought this to replace a junk Utilitech pump. Nice looking pump, seems well built and it's not as noisy as the other pump. Very happy so far...

I am extremely pleased. The price was outstanding and the pump is ideal. I have high mineral content in my well water and cast-iron pump housings just don't cut it in the long run. The stainless steel pump body is perfect for the situation and the pump cycles beautifully, providing a continuous flow superior to the pump it replaced. The flow-rate to cost ratio on this unit is extraordinary. Thanks! We'll be in touch!